Every biker know the pain of lost pin 🙁
Here is my example. Repair is incoming!
I bought different size of pins ( total cost ~1 euro )
If you are lucky, just screw the pin.
If you are not very lucky, screw the ping using pliers.
If you are not lucky, use small hammer.
If you are not luck at all, there is some work to be done.
We will fix the pedal using the idea of “delta” pedals.
Repair the hole, using small drill. Start with very very small. You can make hole bigger, but can’t make bigger hole smaller.
Even the surface using resp. Around 20 seconds of work.
Picture above = work done.
Use tap carving to repair the curve.
Repeat the step with the resp.
Here is one too long pin.
Pin mounted.
Here is mounted pin, but it is too short.
If pint can’t hold by itself, use nut. Smaller nut is better.
Example with nut.
In my case 8mm pin fitter perfectly 🙂
I’m shoping form local shop ITT, total cost of pins: 0.3 euro.